Description

UC 311 is a general purpose, thixotropic, solvent free, two-part epoxy adhesive with a mix ratio of 1:1.

Product Application

As a general-purpose adhesive for most materials, excluding certain plastics and stainless steel.

As a filler where it may be bodied with fine materials such as wood flour, silica sand or talc, to match the material being filled.

As a grouting medium for fixing dowels and/or bolts horizontally into concrete.

Surface Preparation

As with all epoxy systems, surface preparation is of prime importance.

All surfaces that are to be bonded must be clean, sound, and dry,free of any foreign matter and contamination.

Smooth surfaces should be roughened by an appropriate method.

Note that when in doubt, a small test area is recommended to check adhesion.

Priming

No priming is required

Mixing

Mix on a flat clean surface, such as a board or plate.

Mix ratio 1:1.

Prepare equal parts of base and activator and place on cleaned mixing surface.

Using a paint scraper or flat mixing blade, mix the two components until completely homogeneous.

Should a filler be required, it should be added after thorough mixing of the base and activator.

Use immediately after mixing.

Application

Apply with trowel, spatula, or putty knife.

Cleaning

Clean all tools and equipment immediately after use with UC 901as the cured material is very difficult to remove..

Safety

Contact with the skin should be avoided.

Wear gloves and protective clothing.

In case of eye contact wash well with warm water and obtain medical advice.

Please consult the Health and Safety Data Sheet.